Hi,
I am using relogit in one of my papers. I run the same model with three different dependent variables. I works just fine with one of them. But, it doesn't work with the other two, which are no more than subsets of this first variable.
I get the following error messages:
1.
conformability error;
You have issued a matrix command attempting to combine two
matrices that are not conformable, for example, multiplying
a 3x2 matrix by a 3x3 matrix. You will also get this message
if you attempt an operation that requires a square matrix and
the matrix is not square.
However, I know it is a similar matrix with the one that works. The variables do not change, but the dependent one which also takes values 0 and 1 just like the one that works.
2.
matrix has missing values;
You have issued a matrix command attempting a matrix operation
that, were it carried out, would result in a matrix with missing
values; dividing by zero is a good example.
This is a little more perplexing. The model is the same. There is no missing data.
Any suggestions?
Ada Hyso, Doctoral Candidate
Department of Political Science
University of Wisconsin-Milwaukee
Milwaukee, WI 53201
Fax 414-229-5021
E-mail: adahyso(a)uwm.edu
--
relogit mailing list served by Harvard-MIT Data Center
List Address: relogit(a)lists.gking.harvard.edu
Subscribe/Unsubscribe: http://lists.gking.harvard.edu/?info=relogit
